Welcome to the first ever maidstone hackspace competition, we are a new hackspace, so we are looking to get the word out and get some collaberation going.The First cometition will be to design a device which can sort a jar of screws by size, the winning entry we will attempt to build.

• Submit designs by 31st of July
• Images can be design in any software or drawn on a piece of paper but must be submitted as a jpg on the mailing list.
• Stick figures and crude line drawing are fine, we are not judge your artistic ability.

Win a UNO Basic Starter Kit

This kit comes with an arduino board and various sensors and components, list below of every thing in the kit.

• 1 x Arduino UNO R3 development board
• 1 x USB cable
• 1 x Prototype extension board
• 1 x Mini breadboard
• 1 x 5V stepper motor
• 1 x 2003 stepper motor driver board
• 5 x Red LED
• 5 x Green LED
• 5 x Yellow LED
• 2 x Vibration Sensor
• 1 x Flame sensor
• 1 x LM35 temperature sensor
• 1 x Infrared receiver
• 3 x Photoresistor
• 4 x Key cap
• 4 x Key switch
• 1 x Adjustable potentiometer
• 1 x Passive buzzer
• 1 x Active buzzer
• 1 x Jumper cap
• 1 x Large breadboard
• 1 x Remote Control
• 1 x 1602 Screen
• 1 x 9G servos
• 1 x Component box
• 1 x 10p DuPont line
• 30 x Breadboard line(approximately)
• 1 x 220ohm resistance
• 1 x 8*8 dot matrix
• 1 x One digit eight segment tube
• 1 x Four digit eight segment tube
• 1 x IC 74HC595
• 1 x Battery Holder
• 1 x 1K resistor plug
• 1 x 10K resistor plug
• 1 x 9V battery
• 1 x 2.54mm 40pin pin header